Replies to This Discussion

Permalink Reply by Tom T on August 22, 2018 at 9:49am

You could try double sided tape (the foam kind). If you cut it to the exact shape of the spoon handle and head, it shouldn't look funky.

Another idea would be to trace the shape onto the head stock then carefully remove some material so the spoon is slightly recessed in the head stock. That would allow you to use epoxy without worry of it running all over.

A third way would be to epoxy some thin wood strips to the back side. That way you could clean away excess epoxy. Once the epoxy is set, you could use s drop or two of super glue to glue the wood to the head stock. There should be no messy run off with this method.

Lots of options.

• ▶ Reply

Permalink Reply by Ducati Scotty on August 22, 2018 at 10:52am

I’ve got a bit of a time crunch so I don’t think i’ll Have time to carve into the headstock, but that would look great.  Tape is a possibility but I think the idea of mounting to a small piece of wood is great.  Much easier to control things on a smaller piece. It will also add a nice accent piece of wood  

Thanks,

scott

• ▶ Reply

Permalink Reply by Korrigan on August 22, 2018 at 12:23pm

Loctite Go2 is awesome stuff, I use it for soundhole covers and sticking on decorative stuff like this...

• ▶ Reply

Permalink Reply by Tom T on August 22, 2018 at 12:31pm

There are new adhesives coming along all the time. This sounds like great stuff.

• ▶ Reply

Permalink Reply by Ducati Scotty on August 22, 2018 at 4:05pm

That Go2 might be my best bet.  I already have a drawer full of other stuff from them :)

• ▶ Reply

Permalink Reply by Taffy Evans on August 22, 2018 at 1:44pm

Hi, I use the adessive sheets used to fit guitar pickguards, cut to shape and then peel the backing off. I can see a couple of places where  tuning machine screws would fit, they have a nice neat dome head. Or experiment on scrap with the glue you have..

Cheers taff

• ▶ Reply

Permalink Reply by Ducati Scotty on August 22, 2018 at 3:45pm

Adhesive sheets sounds good. I can get screws through, but I’d like to keep it cleaner looking if I can. 

• ▶ Reply

Permalink Reply by Rich on August 22, 2018 at 3:01pm

How about... Flatten the bowl of the spoon, and drill small screw hole for tuner sized screw.

• ▶ Reply

Permalink Reply by Ducati Scotty on August 22, 2018 at 3:46pm

The bowl is super thin crap, not worth saving. 

• ▶ Reply

Permalink Reply by the anonymous pick on August 22, 2018 at 3:46pm

Depending on headstock length and desired placement  .   you may be able to just  drill a hole  into the end of the fretboard (or groove in bottom of fretboard )  and jam the cut end of the spoon  in the  super glued hole .

 

• ▶ Reply

Permalink Reply by BrianQ. on August 22, 2018 at 3:53pm

Loctite Go2 / clear Gorilla glue 

Korrigan that box is sick!!!!

• ▶ Reply

Permalink Reply by Korrigan on August 22, 2018 at 4:11pm

Thanks Brian.  : )

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page