Replies to This Discussion

Permalink Reply by Outhouse Instruments on April 26, 2010 at 12:30pm

Yep, just solder quickly. Let the iron got good and hot, have the solder ready and make sure everything is well tinned.

Matt

• ▶ Reply

Permalink Reply by Roger Morin on April 26, 2010 at 12:31pm

Just try soldering it back on, if it doesn't work your not out a lot of money just get a new one.

• ▶ Reply

Permalink Reply by MichaelS Country Boy Guitars on April 27, 2010 at 2:48am

Solder it on, it should work. good luck

• ▶ Reply

Permalink Reply by Chester Winowiecki on April 27, 2010 at 3:27am

Hi all...just joined after lurking for a long while.

I've had this happen lots of times and you can solder it back together but here's a tip: put a good amount of solder on the tip of the iron and touch to a new spot on the white ceramic until the solder stays. If you leave it there too long it will burn through the layer and not stay. Then take your tinned wire and solder it to the new spot. You can keep trying on new spots if it doesn't work the first time. Good luck!

• ▶ Reply

Permalink Reply by Tracy Kennedy on April 27, 2010 at 6:51am

Thanks guys. Ill have a hand at trying to repair it then. But ill have to put it aside to test later til I get some sorta amp to plug it into. I notice a flea market i go to sells little cheap practice amps for $25 - $35, Ill pick one up.

• ▶ Reply

Permalink Reply by MichaelS Country Boy Guitars on April 27, 2010 at 9:18am

I was playing with my piezo today and now I need to re solder also, I guess my first attempt did not last. I am going to try Chesters method, I heard that on suggested before also so it must work.

Tracy Kennedy said:

Thanks guys. Ill have a hand at trying to repair it then. But ill have to put it aside to test later til I get some sorta amp to plug it into. I notice a flea market i go to sells little cheap practice amps for $25 - $35, Ill pick one up.

• ▶ Reply