Replies to This Discussion

Permalink Reply by Will King on September 9, 2016 at 6:35am

So.....Your finished cat bowl uke looks just my tenors.....I drill a small hole in the box first on a center line (I place the hole as high as I can & still have room for the washer and nut).  I then place the box & neck upside down on the counter and tap a nail through the box hole to make a mark on the neck center line.  I also put a screw near the bottom of the neck to keep the neck aligned.  Your close....just a little adjustment needed.  Happy Buildin'

• ▶ Reply

Permalink Reply by Kigar on September 10, 2016 at 3:31am

I agree with Will that you are close. A possible solution would be to open up the hole and get the position correct, then add a couple screws - sort of like Will did except two side by side.

• ▶ Reply

Permalink Reply by Will King on September 10, 2016 at 4:02am

I am sorry.....My answer was how to make your next build.....To repair you problem.....Just elongate the hole in the box in the direction that you want the neck to move and when you tighten the nut, the neck will stay in place.  Up, down, sideways or diagonal doesn't matter, it will work, believe me, I have had to fix many a problem.

• ▶ Reply

Permalink Reply by Kigar on September 10, 2016 at 5:58am

I am saying pretty much the same thing, but the pictures only show the single bolt, and I suggest adding a screw or two.

• ▶ Reply

Permalink Reply by Lonman on September 11, 2016 at 4:18am

DSC01325.JPG

How do you like the "all in one" nut/fretboard?  Did it sound pretty good? First time I have seen this.

• ▶ Reply

Permalink Reply by Grandpa G on September 12, 2016 at 6:23am

Lonman, This is called a zero fret setup which saves the need to cut an accurate nut. I used the traditional nut setup on the next instrument I built. I like both approaches.

Attachments:

• DSC01333.JPG, 991 KB
• DSC01336.JPG, 1.3 MB
• DSC01335.JPG, 1.3 MB

• ▶ Reply

Permalink Reply by Grandpa on September 12, 2016 at 2:59pm

From one Grandpa to another, nice build!

• ▶ Reply

Permalink Reply by JL on September 14, 2016 at 12:41am

similar idea as others are suggesting ... enlargen up the hole in the box so the bolt has room to be off, then you can shim the neck/box joint to straighten it out, and finish with a wood screw through both to lock it in.

• ▶ Reply

Permalink Reply by Fomhorach on September 15, 2016 at 2:23pm

If your box is deep enough you can go under the bowl with a stick through design.

• ▶ Reply