Replies to This Discussion

Permalink Reply by ChickenboneJohn on June 8, 2010 at 8:50pm

I use a Swann-Morton surgical scalpel with 10A blades- the sharp, stiff blade gives an accurate clean cut, but watch out for your fingers! Use a straight edge and take it easy, too much pressure will snap the blades. I find this goes thru' both solid wood and ply boxes pretty well.

• ▶ Reply

Permalink Reply by Julian Perry on June 8, 2010 at 9:27pm

Hey Alex, I do the same as you with the fret saw for vertical cuts, but then I get a real sharp chisel, support the box edge on the back with a block of wood, line up the flat side of the chisel with the pencil mark and give it a whack. If you make sure the angled side of the chisel is facing the wood to be removed, you should get a nice clean cut. If you only have a narrow chisel tap it gently and move it along the pencil line side to side until piece comes free. Works for me.

• ▶ Reply

Permalink Reply by Outhouse Instruments on June 8, 2010 at 11:57pm

Julian Perry said:

Hey Alex, I do the same as you with the fret saw for vertical cuts, but then I get a real sharp chisel, support the box edge on the back with a block of wood, line up the flat side of the chisel with the pencil mark and give it a whack. If you make sure the angled side of the chisel is facing the wood to be removed, you should get a nice clean cut. If you only have a narrow chisel tap it gently and move it along the pencil line side to side until piece comes free. Works for me.

This is how I do it.
It is quick, easy and it works.
But I do clean the edges up ( if needed) with a very sharp chisel and small, purpose built sanding block.

Matt

• ▶ Reply

Permalink Reply by BenBob on June 9, 2010 at 4:25am

I just used a coping saw. 60-grit and a block squares it all up nice and quick.

• ▶ Reply

Permalink Reply by Michael Gajeski on June 9, 2010 at 5:23am

a dremel with a cut off wheel and a file to clean it up.

• ▶ Reply

Permalink Reply by Dave Breault on June 9, 2010 at 5:52am

I used to do that, now I do all the cuts with a copping saw, a little sanding and Bob's your uncle.

• ▶ Reply

Permalink Reply by Shawn on June 9, 2010 at 9:58am

I use a dremal with a downward spirel bit from a roto zip cut just up to the line and file the rest and sand smooth. Take care the dremal will try to run on you

• ▶ Reply

Permalink Reply by Tracy Kennedy on June 9, 2010 at 11:52am

I chew on mine a bit, takes awhile but they turn out alright and besides I need the extra fiber in my diet

• ▶ Reply

Permalink Reply by BenBob on June 9, 2010 at 12:29pm

And if you're good at it, you can turn out a couple toothpicks for when you're finished.

Tracy Kennedy said:

I chew on mine a bit, takes awhile but they turn out alright and besides I need the extra fiber in my diet

• ▶ Reply

Permalink Reply by Michael Gajeski on June 9, 2010 at 2:21pm

wow... i just tried the razor blade/fret saw method on a new guitar i started this week. It was easier and took less effort than I would have ever thought. It may have taken 5 minutes to do it and file it to perfection. The dremel is still faster, but at least I know I can live without it.

• ▶ Reply