Replies to This Discussion

Permalink Reply by Keith on April 2, 2015 at 12:14pm

only problem I can see is the lack of break angle.  by carving the back instead of the front it puts the tuners high enough that the strings don't "break" over the nut potentially causing tone issues.  if it sounds ok and doesn't buzz it's cool but I wouldn't count on it working every time.

• ▶ Reply

Permalink Reply by Scott aka Farmer Ted on April 2, 2015 at 12:21pm

Keith is right. No break angle and at minimum you get buzzing strings. Two choices to correct it. String trees or other device to lower the string angle from the tuning pegs toward the nut. Or, see Wayfinder's discussion titled "Mild Insanity". The pictures are self explanatory, and will offer an alternative to this.

Best of luck.

• ▶ Reply

Permalink Reply by darryl kernaghan on April 2, 2015 at 12:25pm

Ii appears you have some type of string tee/restraint,so all should be ok,as Keith says,as long as you have a good break over the nut,it'just about how you want it too look

• ▶ Reply

Permalink Reply by jeffrey ross on April 3, 2015 at 1:26am

I back cut most of my head stocks this way. I have found using small eye hooks as string restraint works for me. I can get exact spacing the way I want it and it keeps the strings low as well. Looks awesome, would like to see the rest of it too!!

 

• ▶ Reply

Permalink Reply by Hex on April 3, 2015 at 7:33am

Oh dear, I thought as much, it will annoy me forever If I don't change it. On the other hand can I de-construct without ruining it before I fit a new neck, uummmm tricky

• ▶ Reply

Permalink Reply by Hex on April 3, 2015 at 7:47am

Here she is

Attachments:

• 20150403_193855.jpg, 911 KB

• ▶ Reply

Permalink Reply by John Sawyer on April 3, 2015 at 7:53am

Nice! If your break angle is too small, you can use a small flat headed machine screw as a tree to pull the string down...

• ▶ Reply

Permalink Reply by jeffrey ross on April 3, 2015 at 8:37am

I use the small eye hooks the same as the screw, they just hold the string down and in the right spot. You can spread them out or put three in a row right behind the fret board. Just pre drill and screw them in to the desired height. Even adds a bit of color to the head stock.

• ▶ Reply

Permalink Reply by John Sawyer on April 3, 2015 at 11:21am

ooh, Shiny!

• ▶ Reply

Permalink Reply by Hex on April 3, 2015 at 5:53pm

Nice! What is the finger board made of?

• ▶ Reply