Replies to This Discussion

Permalink Reply by John Sims on January 2, 2009 at 3:55pm

Piezo's are very high impedance, so the 500 K pots should be fine. Also, the .047 uF cap is the right value. What is the distance fromn the pickup magnets to the strings? THIS THREAD may be the answer to your issue. Here is the exact same wiring on a lap steel guitar I have, so it may be that there is a short or an open wire in your rig...

• ▶ Reply

Permalink Reply by Lucky on January 3, 2009 at 4:58am

John thanks for the diagram and the link, there ae no magnets, no pickup, just the Piezo. I'll check for shorts and not sure what an open wire is , but will look at all the connections again.
Piezo's are very high impedance, so the 500 K pots should be fine.
Also, the .047 uF cap is the right value. What is the distance fromn
the pickup magnets to the strings? THIS THREAD
may be the answer to your issue. Here is the exact same wiring on a lap
steel guitar I have, so it may be that there is a short or an open wire
in your rig...

• ▶ Reply

Permalink Reply by Gary Krepak- Sole Food Diddley Works on January 12, 2009 at 3:39am

You need a preamp man. No way around it, and the use of 2m pots is essential to keep from getting your bass notes squashed.

• ▶ Reply

Permalink Reply by THENUGE on March 6, 2009 at 1:39am

http://www.1728.com/guitar.htm

• ▶ Reply

Permalink Reply by Blind Lightnin on March 8, 2009 at 4:48pm

seymour duncans website has tons of diagrams

• ▶ Reply

Permalink Reply by berlina on March 9, 2009 at 9:46am

I only have volume control on my piezo equipped cbg. First I had a 500K pot wired the usual way (only on positive lead), but it didn't lower the volume to zero, and the tone got kind of muddy on lower settings. But then I wired a 1M ohm pot as a voltage devider and it worked out just fine.

Attachments:

• Piezo.jpg, 37 KB

• ▶ Reply

Permalink Reply by Roosterman on March 12, 2009 at 3:20am

So did you get it sorted Lucky?
Im having a similar problem with mine - I added a tone and vol to my box (mine does have a single coil), and though the tone works fine, the vol only seems to work between '1' and '2'.... nothing appears to happen between '3' and '11'. It kinda works as an on / off switch rather than a volume. I used the same wiring diagram from Seymour Duncan, its wired correctly... the only thing I havnt got is an earth to bridge, as its not metal, its wood, but cant see this would cause the problem. I see theres some discussion on pot size, but with a single coil, the cheap chinese pots I salvaged from a LP copy should be fine, no?

• ▶ Reply

Permalink Reply by Dan Tomkinson on December 27, 2009 at 2:45pm

I just use the controls on my amp

• ▶ Reply