Replies to This Discussion

Permalink Reply by David L. on May 20, 2012 at 7:20am

you can use a blend pot

I have used these off ebay http://www.ebay.co.uk/itm/5-Dual-B250K-Blend-Balance-Pot-Potentiome... they take 4-6 weeks to arrive.

On my next build (whenever I get around to it) I want to give this idea a try where you use 1N5817  diodes on the pot so you can use then direct without the need of an extra blend pot. http://www.strat-talk.com/forum/stratocaster-discussion-forum/13405... I don't know if it will work okay with a piezo but cannot see any reason why it shouldn't.

• ▶ Reply

Permalink Reply by The Phrygian Kid on May 20, 2012 at 6:11pm

in my experience that circuit (that David put up) works better when you leave the earth off..

otherwise at each extreme you get nothing..

i also buy plenty of balance pots from ebay, i use em for two in one tone controls too

• ▶ Reply

Permalink Reply by BenBob on May 20, 2012 at 7:41pm

Is it possible to use two volume pots and run them in parallel?

• ▶ Reply

Permalink Reply by The Phrygian Kid on May 20, 2012 at 8:07pm

Yes it is. That is exactly what a balance pot is btw, just the two are stacked. In the centre both are on ten. As you roll forward one is rolled of, backward the other. I use em all the time. I'd much prefer a blender and a master volume than two volumes personally.
Make sure you get a balance pot, they got a special taper otherwise witha regular stacked pot in the centre both pups are on less than ten

• ▶ Reply

Permalink Reply by Rouxdy Blues on June 2, 2012 at 2:10am

I'm thinking this is what I want to do on one of my current builds.  This is all pretty new to me so my question is this... can I use a 250K pot for volume with my 500k Bourns Blend pot?  And is there a schematic somewhere!? 

Thanks in advance!

• ▶ Reply

Permalink Reply by Johannes Eriksson on May 21, 2012 at 10:29am

Thanks everyone for your help, I was expecting it to be less straightforward than that but if the only difficulty would be that one pickup would be louder than the other then the blend pot should be able to take care of that...

• ▶ Reply