Replies to This Discussion

Permalink Reply by Grandpa on April 4, 2016 at 12:12pm

I thought that might be the way to go. Thanks.

• ▶ Reply

Permalink Reply by John Sawyer on April 4, 2016 at 7:40pm

Mostly, I've built my own boxes... the first was pine, the other 2 have been 1/4" jatoba and purple heartwood, with thin plywood backs.  For the acoustics, it was neck-TO (to the end of the box) the electric I added cross-pieces to support the end of the neck to make room for the pickup.

I recently finished a solid body guitar neck-to, out of poplar with a maple neck and a Gitty 3-string hard tail.  It is awesome!

• ▶ Reply

Permalink Reply by Rob on April 5, 2016 at 10:15pm

Very nice Git. At the moment i build my first license plate CBG. Try to mix good playability with used look ... 

Box is made out off old palette timber i found laying around, neck is maple and fretboard is Afzelia (Doussi) from West Africa (hardness close to Bamboo).

• ▶ Reply

Permalink Reply by John Sawyer on April 6, 2016 at 5:20am

Looks awesome! You might have to support the plate at the bridge if you have a gap under the plate...

• ▶ Reply

Permalink Reply by Rob on April 6, 2016 at 7:42am

There is a gap. Its a neck-to design with a bolt on neck. Back of the box is a thin piece of a special kind of timber which is used for roof tiles. It has something like a 3 dimensional strukture, is thinn but very robust.
My plan is to drill a hole in the neck right below the bridge. Thru this hole i connect (without any contact to the neck) the back with the license plate to support the bridge and forward the vibrations to the back. One piezo will be right under the bridge, the second on the back right where my reinforcement piece is conected with the back.

• ▶ Reply

Permalink Reply by Kigar on April 6, 2016 at 3:00pm

If it is an older plate it could be stiff enough to go without a brace.  New ones are to thin but the plate I used was only supported around the edges with small blocks at the screw holes.  I used a floating bridge and a piezo underneath. It is about a year old and no sag to my eye.

• ▶ Reply

Permalink Reply by Grandpa on April 6, 2016 at 10:22am

Very nice looking build. I love old lumber with funky broken patina. I have found some old ratty oak shelves that I have used for git box building and I am always looking for more. Again, a very tasty build!

• ▶ Reply