Replies to This Discussion

Permalink Reply by Dale "Guv'nor" Crombez on June 4, 2015 at 2:21pm

Skeesix, thanks for the reply.  That (temporary alligator clips) was what I was planning on doing.  Just need to find the time.  Hopefully this weekend.

I just hope these coils work good since it will make making mag pickups easy.

I will definitely check out this book.

• ▶ Reply

Permalink Reply by Taffy Evans on July 1, 2018 at 1:38am

Stacked humbuckers are available, they are two single coils and can fit into a normal single coil cavity.

Taff

• ▶ Reply

Permalink Reply by Paul Craig on July 1, 2018 at 9:23am

When using multiple pickups, it's best to alter the wind direction and magnet polarity to keep phase issues at bay. Unless you like the thinner sound associated with the phase condition.

The coils your using may have a low output depending on wire gauge and amount of wire in each coil. Do you have a DCR value for each coil your using?

Low output coils would be better in series. Example being a lipstick tube pickup at 4k DCR compared to a Strat pickup at 5k to 6k DCR. The lipstick tube has a good tone, but often has to be played at loud volumes with big amps to get that goodness from them. Wiring the individual coils in series doubles their output. So 2 lipsticks would then be 8k DCR which is equivalent to a Gibson PAF Humbucker in output and 2 Strat at 10k to 12k DCR for a slight overwound humbucker.

So if each coil reads 1k DCR and you had 6 of them. They would read 6k DCR in series, but only 1k DCR in parallel. Another way would be 2 groups of 3. Each group wired in series and the 2 groups then wired in parallel for 3k DCR.

Hope that helps and doesn't further confuse. More than one way to skin a cat, but it won't taste like chicken. Sorry Nancy. Haha

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page