Replies to This Discussion

Permalink Reply by Jantan ux on July 5, 2013 at 10:29pm

Anyone ever used Wolfcraft tecmobil  ?

• ▶ Reply

Permalink Reply by David L. on July 5, 2013 at 11:14pm

Hi,

I haven't tried these products (I have a cheap bench drill I use) but recently watched this video on youtube showing how to make 90 degree holes with a cordless drill.

http://www.youtube.com/watch?v=vZ58uj6RwSQ

• ▶ Reply

Permalink Reply by Jantan ux on July 7, 2013 at 10:34am

This method what is shown on youtube only works once or two. Because drill bit damages wood .

• ▶ Reply

Permalink Reply by Skeesix on July 6, 2013 at 6:52am

The Tecmobil looks similar enough to the Craftsman. I think it would drill holes at 90 degrees. The only problem might be how to hold the tune-o-matic bridge in place while you're drilling. Maybe something like putting a board in the bottom of the drill guide and using double sided carpet tape to hold the bridge to the board.

I think the Switch and Lock drill mount would work for a disc sander, if you put a board in front of it like you're saying. It could also make a great pickup winder!

• ▶ Reply

Permalink Reply by Jantan ux on July 6, 2013 at 8:51am

Hole on body is small. Not the hole in bridge. I have corded drill with 41mm collar.

Tecmobil what is in estonia  on sale are without chuck. It's meant for corded drills with 43mm collar.

• ▶ Reply

Permalink Reply by Pete Turner on July 7, 2013 at 4:18am

For years I've taken my old single speed black & decker clamped it upside down in a vise mounted to my work bench. (Be sure to protect the drill by putting an old rag/carpet piece between the steel jaws.) Tighten enough to hold the drill firmly in place but not to tight to damage drill. I also do the same thing w/my belt sander, turning it into a bench sander. Hope this helps!

• ▶ Reply

Permalink Reply by Jantan ux on July 7, 2013 at 10:02am

I'm not vise the drill. I made Switch N Lock Drill Mount.

Vise is bad Idea for drill etc.  If someone modifies clamps can make something like this for cordless drill.

I have to upload pictures from my camera to computer. Right now I can't show my drill mount.

• ▶ Reply