Comment

Comment by darryl kernaghan on May 4, 2017 at 12:27pm

Thanks guys, but no great credit to me, i just added a few wires, pretty simple job

Comment by Uncle John on May 4, 2017 at 3:01am

that is like a battle sip of cool, Darryl!  

Comment by Jerry Jordan on May 4, 2017 at 12:08am

very nice.,.,reminds me of grandmas nightstand.,.,

Comment by Dave Lynas on May 3, 2017 at 11:08pm

Thanks again Darryl. My volume pot has the switch also on the pot. However the pot has the three tabs. So, just like a guitar volume pot setup. Cool! I have a show Saturday so it will be Sunday before I can mess with it. THANKS a heap.

Comment by Rock-Schorsch on May 3, 2017 at 7:08pm

Great, i like this!

Comment by darryl kernaghan on May 3, 2017 at 4:05pm

Dave,Looking at the pot from the rear, with tags facing down, left should be the input, middle output, and right ground, i used the pot ground on mine to the jack, also i didn't mention earlier, that the middle, [switched common] lug from the switch went to the input on the pot

Comment by Dave Lynas on May 3, 2017 at 2:56pm

Wow, thanks for the great info Darryl. I didn't disconnect the input from the radio. I should be able to figure out which lead is the input. I could add a switch after probing the volume pot? Right? I also grounded to the metal chassis, not the back of the volume pot. I'll try that too. Soon I'll try again. Thanks Darryl.

Comment by darryl kernaghan on May 3, 2017 at 11:58am

Dave, i just disconnected the input wire to the volume pot, patched in a 3 way,[that's all i had handy] with signal from radio on one leg, and signal from jack to the other, and ground from jack to ground on pot, i'm not 100% sure whether that is the best option, as the amp volume was about 1/2 the radio  volume, and  it may have missed some circuitry needed from the radio, however, the simple in line impedance matching amplifier that i use on my "induction" type pups fixed the issue very well, so i,m reasonably sure that it was just an impedance miss match, then when i added the pedal it really screams

Comment by Dave Lynas on May 3, 2017 at 11:43am

I am impressed! I want to learn the hookups for conversion.

Comment by Gary W aka Rev. Bluejeans on May 3, 2017 at 10:56am

Nicely done!