Replies to This Discussion

Permalink Reply by darryl kernaghan on November 1, 2013 at 1:02am

even the sliding is not much of an issue,just leave a little "green" on the head to trim later,a little bit of sanding,trimming and you,re done,if sliding sideways is an issue,just clamp a temporary fence to maintain alignment

• ▶ Reply

Permalink Reply by Mark Lindsay on November 1, 2013 at 4:28am

Hi Jeff. Here's how I keep the parts from sliding around when I clamp a scarf joint: http://www.cigarboxnation.com/video/how-i-clamp-a-scarf-joint

• ▶ Reply

Permalink Reply by Rouxdy Blues on November 5, 2013 at 8:20am

That's what I do as well and it works really well.  

• ▶ Reply

Permalink Reply by ChickenboneJohn on November 1, 2013 at 12:59am

There's nothing wrong with what you've made, other than the fact you haven't put the strings on right. Leave more slack so you get several winds round the string posts and always wrap them DOWN towards the headstock to increase the break angle..problem solved.

• ▶ Reply

Permalink Reply by Brendan deVallance on November 1, 2013 at 2:15am

I added a bit of wood to the underside of the headstock to help coax the tuners into the right spot.

• ▶ Reply

Permalink Reply by Groucho on November 4, 2013 at 6:35pm

I am lacking in power tools as well.  What I've done is use a coping saw to cut an angled piece off of the headstock.  Then flip the piece over and glue the two flat sides together.  That will give you an angled head.

The cut from the blade and then sanding the rough outer sides smooth should take enough off the wood so that the tuners poke through enough to wind the strings around.  

Call it "the poor man's scarf joint"....

 

• ▶ Reply

Permalink Reply by jabes on November 5, 2013 at 12:47am

i've made a couple of dozen guits and all my heads were done like this, no problems at all.

• ▶ Reply

Permalink Reply by RTZGUITARS on November 5, 2013 at 10:31am

If you need a string tree the fender type only cost $ 3. this is what I do to keep the joint straight.

And John is right you need to wind the strings down lower

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page