Replies to This Discussion

Permalink Reply by colin mcgrath on April 13, 2011 at 6:32am

That is a great picture of the set-up. I might try that with this build.

• ▶ Reply

Permalink Reply by Mark Bliss on April 14, 2011 at 5:43am

A bolt on is feasable, (bolted to a neck block, acoustic style. Not flat like a Fender.) I like the barrel bolt method, that combined with either a glu joint or a dovetail/mortise, or both.

Not to set a negative note, but Colin, the fretboard and frets appear to be in VERY poor condition, Depending on your expectations it may not be worth all the trouble.

• ▶ Reply

Permalink Reply by colin mcgrath on April 14, 2011 at 6:16am

To be honest I have no expectations for the impending build. Other than experience on successfully assembling the guitar.

The condition of the guitar was VERY poor. It was evidently a dumpster guitar that my local git shop had for a while and just decided to sell, the tailpiece pickguard and 3 post tuner I got off it are worth the 8.50. The fact that the neck was not bowed beyond reuse was a shock to me. Besides if worst comes to worse I can always remove the fretboard and install a new one. Shoot I will even have to install a new nut. Check out this headstock pic, the low E slot is busted.

• ▶ Reply

Permalink Reply by Edgel R Gillespie II on April 14, 2011 at 3:45pm

Such a great find, I have an add on a local bulletin board for damaged wares...... people seem to want the moon for their broken junk out here. Really good find, especially the age of the fret board, that will make a superb piece :) Maximo

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page