Replies to This Discussion

Permalink Reply by Ron "Oily" Sprague on December 26, 2012 at 7:05pm

That's nice, Tom! Send a vid or audio file when you get 'er strung up.

Permalink Reply by Tom Walters on December 28, 2012 at 4:45am

Here's an update.....put on the back and sprayed on some finish.

Tom

 

 

 

 

Permalink Reply by Order99 on December 28, 2012 at 8:46am

That is one drop dead gorgeous build-i'll bet it plays as good as it looks when you're done!

Quick question if I may-did you need any reinforcement of the box for the cat dish or was the soundboard sturdy enough to just epoxy it in? Do you forsee any trusses in the Catbro's future?

Permalink Reply by Tom Walters on December 28, 2012 at 9:49am

Order 99,  I did put a piece of 1/4 plywood under the dish and two cross braces for support - one on the end and one in the middle.  I drilled holes through the middle brace so sound could come out to the soundholes.

 

The build is done.  Here is my son holding the finished product.  Corian for the nut and bridge.

 

Now I will try and post a video of my son playing it.  Never done this before.

 

http://www.youtube.com/watch?v=QOvBZe_Fqcs&feature=youtu.be

Permalink Reply by Joe Caruso on December 27, 2013 at 6:57am

Thanks for posting the pics!  Neat recycling of the salmon box and the final product looks great! 

Permalink Reply by Rand Moore on January 1, 2014 at 6:19pm

Hi Tom Walters,

I finally noticed the hole cutter you used to cut the hole for your cat bowl resonator "cone". Can you tell us more about it? I have to resort to pretty primitive (and clumsy) means to cut such large holes (so I rarely do it). It would be nice it there was an easy and safe way to do it w/o spending big bucks. Tell us how it works.

-Rand.