Replies to This Discussion

Permalink Reply by Bluesheart on March 25, 2013 at 10:11am

You could add a vol. pot there  and put the jack on the tail end too.

• ▶ Reply

Permalink Reply by Jon Leslie/Runaway Veal Music on March 25, 2013 at 10:36am

How easy is a volume pot..Good ideas. Of course I'll check the site. Is there a volume pot that's easier than others to assemble than other kinds?

• ▶ Reply

Permalink Reply by gary herget on March 25, 2013 at 1:52pm

check out the group, cbg wiring and electronics and you should find all the info you need to wire a vol. pot. You'll find diagrams you can use as well. You can pick up a pot at Radio shack cheap enough for getting started.

• ▶ Reply

Permalink Reply by jeff maurer on March 27, 2013 at 2:48am

ive ran into this problem myself up on the headstock drilling for my tuning pegs. get a wood dowel rod and glue it in and after it dries cut it flush. but my headstocks are probably thicker that what you are currently dealing with right now so im not too sure it will work.

• ▶ Reply

Permalink Reply by jabes on March 27, 2013 at 7:01am

point an arrow and write 'oops'...? how do you damage a jack socket?

 

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page