Replies to This Discussion

Permalink Reply by John Robbie on November 22, 2012 at 2:10am

• ▶ Reply

Permalink Reply by John Robbie on November 22, 2012 at 2:11am

Hey Dan, might be best to show this past a few other people to check... I'ts late here and I've been building valve stuff for too long, the solid state stuff is a bit rusty! 

• ▶ Reply

Permalink Reply by John Robbie on November 22, 2012 at 10:56am

Hey Dan,

I had a look over this with a coffee this morning, you will want to use this one, with the other one I did the momentary switch wouldn't work like you need it to.

The new circuit will allow you to push the button once to get the lights flashing for up to about 15secs, adjustable down to a couple of seconds via the pot.

Go with this one. 

• ▶ Reply

Permalink Reply by Dan Sleep on November 22, 2012 at 11:42am

Thanks!! I will see what I can do with it.

• ▶ Reply

Permalink Reply by RTZGUITARS on November 23, 2012 at 12:42am

I didnt read the comments but you could run a simple flasher and bypass it with another switch

so they are always on

 

 

or do this for a flashing then solid light

 

• ▶ Reply

Permalink Reply by BUGGY (C) on November 23, 2012 at 6:07am

Try Maplins.co.uk as they have lots of ready made circuits that might give you some directions as to they components used

I been trying to learn electronics all my life, but as yet havent made a successful circuit board to work.

 

 

 

• ▶ Reply

Permalink Reply by BUGGY (C) on November 23, 2012 at 6:10am

http://www.maplin.co.uk/dual-superbright-redflashing-leds-34161

• ▶ Reply

• ‹ Previous
• 1
• 2
• 3
• Next ›
• Page