Replies to This Discussion

Permalink Reply by Kigar on May 10, 2017 at 3:27pm

Some ideas - If you wanted it more rustic you could rough sand or wire brush the pink away.  If you wanted it nice you could finely sand or strip it away.  To cover it the cheapest thing would be a can of spraypaint I would think.  To darken it you could lightly burn it with a torch but this could end badly so be careful! If you consider the last one check out youtube for bringing out the grain with a torch.

I usually say to practice on some scrap but in your case you don't have much choice but to pick an approach and go for it!

• ▶ Reply

Permalink Reply by Reverend Bow on May 11, 2017 at 2:48pm

I actually have a similar issue at the moment with a 18.5" scale Hondo 6 string that is 1/2 a shade darker than safety blaze orange...

I'm going to strip it and stain it... I'm pretty sure the body is plywood on mine.

I heat gun works very well to strip modern finishes, you here it up and work it off with a putty knife. Then you just need to sand off the primer.

I've done this to 2 guitars and it worked out pretty well.

• ▶ Reply

Permalink Reply by Skeesix on May 12, 2017 at 3:05am

How doing something with Mod Podge? Cover it with something like wrapping paper, fabric, photos, etc. then clear coat with Mod Podge. Might work for everything but the neck. 

There was a guitar I was considering purchasing on eBay that had sparkles glued or Mod Podged all over the body. 

https://www.google.com/search?q=guitar+with+sparkes&oq=guitar+w...

• ▶ Reply

Permalink Reply by Paul Craig on May 12, 2017 at 8:29am

You can buy some acrylic paints at your local hobby store and mix with water to get the desired tint and rub on or use a sponge brush. Spray acrylic clear on top. 

• ▶ Reply