Replies to This Discussion

Permalink Reply by Scott aka Farmer Ted on October 27, 2014 at 6:41am

Unless you're adding a "coil-tap" feature with push-pull potentiometers, its pretty easy. For each pickup, just solder the red & white together and either wrap with electrical tape or seal with shrink tubing to eliminate the chance of the wires touching other metal parts inside and grounding out.  Connect black to ground ( negative) and green as your pickup signal (positive) out to the toggle switch. (note: don't solder both reds & whites together in a group of 4 wires, just do this step for each individual pickup). Once this is done, and each green signal wire is connected to the 3 way switch, its just a matter of finishing your volume & potentiometer wiring and thru to the jack.

Good luck

• ▶ Reply

Permalink Reply by Robert Phillips on October 27, 2014 at 1:28pm

Ok, that makes a lot more sense for me than what it said on CB Gitty. I needed that extra little bit of explanation.

• ▶ Reply

Permalink Reply by Robert Phillips on October 28, 2014 at 9:33am

Well there it is. Don't make much sense to me looking at it but it makes a good sounding guitar :D

• ▶ Reply