Replies to This Discussion

Permalink Reply by Wichita Sam on July 11, 2009 at 2:04am

Mark,

Thanks, great information. I sometimes ask the obvious, since I often didn't know it until someone pointed it out to me....

the best,

Sam

Mark Werner said:

Oh, sure. My drill press gets a good workout installing tuners.... I was dealing with the "Ping" tuners that are likely made in China; a good value for the tuners themselves, but cheap hardware.

I was going to say before....If you can't find the tiny screws, it's a simple matter to slightly drill out the screw holes in the tuner itself to accept a slightly larger item.

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page