Replies to This Discussion

Permalink Reply by darryl kernaghan on October 20, 2016 at 3:12pm

You seem to be winning Richard, but that lack of further travel is going to restrict your chances of intonation a bit, but if you shorten the spring a bit, it looks like you can get another 4-5 mm, and that will get you pretty close i'd think, you might need to shorten the screws a touch as well, i can't tell by the pic how close they are to the strings. An alternative might be to put a nice hardwood spacer behind the bridge, and have your screws come from that after drilling the holes in the bridge upstand large enough for the springs to go through.

• ▶ Reply

Permalink Reply by Fomhorach on October 20, 2016 at 10:20pm

Getting there.

I would bite the bullet and move the bridge back to the guitar edge.  Sure there might be two little holes but two pop rivets or a small decorative handle can sit over the bridge and tidy it up.

Edit- closer to the guitar edge, too far back will cause similar problems.

• ▶ Reply

Permalink Reply by Richard Wilkins on October 21, 2016 at 1:11pm

Moving it back a little bit was my very first thought but I was concerned about drilling four new holes directly in line with--and so close to-- the old holes. Would there be a chance of the wood splitting?

• ▶ Reply

Permalink Reply by darryl kernaghan on October 21, 2016 at 1:49pm

I don't know what products are available where you are Richard, but most epoxy timber fillers can be drilled right beside, or even 1/2 way across an existing hole once set, if you are careful, you could plug your old holes, move the plate back so it JUST covers the old holes and re - drill, a tiny patch of wood glued under the 2 front holes inside the box would almost certainly help to stop your plugs ever coming out. Of course you could do what i said without even plugging the holes, just use a thicker piece of wood inside the box to screw into, as long as you don;t slide the plate back too far and expose the old holes it should be ok

• ▶ Reply

Permalink Reply by Danny B. on October 23, 2016 at 11:55pm

The thing is gorgeous though.

• ▶ Reply

• ‹ Previous
• 1
• 2
• 3
• Next ›
• Page