Replies to This Discussion

Permalink Reply by Thumper on October 12, 2015 at 4:13am

I bend pieces to shape around the heel of the neck and glue them in place right against the box. It takes care of my less than perfect cut's while making the neck slot.

• ▶ Reply

Permalink Reply by Ron "Oily" Sprague on October 13, 2015 at 3:51am

Internal snare for a cajon. ;-)

• ▶ Reply

Permalink Reply by Two Dog Guitars on October 14, 2015 at 7:16am

How do you garrote a CBG?

• ▶ Reply

Permalink Reply by Bama Hound on October 14, 2015 at 3:13pm

     I can't tell Ya', the statute of limitations doesn't run out on that. (:-D)

• ▶ Reply

Permalink Reply by John Sawyer on October 14, 2015 at 5:46pm

Good point! you could take the Ebe strings and just go Ebe...

• ▶ Reply

Permalink Reply by BP - RabidSalad - on October 15, 2015 at 4:03am

Its often the simple things that elude us....  well me anyway. 

I've started making more three string than fours because I can make more of them with the pieces I get.  I'm also not musically gifted either so like those Thanksgiving left overs you keep pick'n away at them because they're to good to toss out. So now I can get rid of a few more of the fatties in a CBG legit way.  Found a place on fleabay to buy strings bulk cheaper than buying packages of strings.  So I'm only buying the ones I use most of, .024, .018 & .011's 

As for leveling...  I use an old aluminum level which I can give it several whacks along the length to help seat any frets sitting to high.  Then I mark them with a marker and sand them down with a long sanding block till all the marks are gone. 

Thx for the tunings for them other strings.

• ▶ Reply

Permalink Reply by Primitive Acoustics on October 15, 2015 at 3:35am

EBeb is one of my favorite turnings for fretted acoustic.

• ▶ Reply

Permalink Reply by BP - RabidSalad - on March 24, 2016 at 1:53pm

Just came across another use for those Fat E strings. 

Seen a lot of yak'n about grounding the piezos and pots etc...  Heres what I did.  Too a fatty and soldered it onto the one side of the piezo.  Drilled a hole thru the bridge and box.  Cut a small channel with a three edged file for the wire to sit on.  Bent the wire 90 degrees and laid it in the channel with the strings pressing it down...  Works like a charm... 

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page