Replies to This Discussion

Permalink Reply by greg on July 28, 2012 at 5:29pm

The neck I'm using is most likely off a tenor banjo.  22 frets, about 19 inches from nut to the end of the fret board.

Greg

 

• ▶ Reply

Permalink Reply by BUGGY (C) on May 27, 2013 at 7:04pm

Is there an easy way to make an accurate scale guide for cutting fret slots?

• ▶ Reply

Permalink Reply by Suspect Device on May 28, 2013 at 3:31am

Hey Bug, not sure if this is what you are after, but I made these fret scale templates out of cheap aluminum yardsticks. Scribed with an exacto knife and then notched with a thin hacksaw blade.They work great for marking frets, but also for initial layout, etc. 

• ▶ Reply

Permalink Reply by Suspect Device on May 28, 2013 at 3:35am

Oops! just realized I posted a pic of these earlier in this thread. But there are more scales in this pic.

• ▶ Reply

Permalink Reply by BUGGY (C) on May 27, 2013 at 8:19pm

Is there an easy way of doing a fret guider
As mine still seem to be out?

• ▶ Reply

Permalink Reply by Clarky on May 27, 2013 at 11:18pm

I use the Wfret program for windows, you can download it for free, just do a quick Google. You just pick the number of frets and scale (I go with 22 fret fender) and it's always worked for me.  Print it off and then just mark the neck all the way up from the nut with a pencil.

• ▶ Reply

Permalink Reply by BUGGY (C) on May 27, 2013 at 11:22pm

Do you need to allow for string angle
When fretting?
Does it make any difference to fret scale?

• ▶ Reply

Permalink Reply by Diglydog on May 28, 2013 at 4:03am

Yes (ideally) and yes (a bit).  I didn't used to bother and my CBGs played sharp, especially on the lower frets.  I now use this calculator that allows for stretch compensation and it's much better.

http://windworld.com/features/tools-resources/exmis-fret-placement-...

• ▶ Reply

• ‹ Previous
• 1
• 2
• 3
• Next ›
• Page