Replies to This Discussion

Permalink Reply by lenny purnell on January 2, 2009 at 4:27am

I ask this same question yesterday and Jay sent a picture of some soundhole covers he use's If you go to the low budget land group you'll find those there. I'm new too. Still getting the hang of the site. I bet if you turn some down on that lathe they would be sweet. lenny

• ▶ Reply

Permalink Reply by Mark Vickroid on January 2, 2009 at 4:52am

Try chromed plastic or metal grommets / hole covers from the office supply store for passing wires thru desks. Drill a few holes in 'em and they work nice. I've used quite a few things from the hardware isle at the hardware store, the misc. parts bins at Ace and Do It Best hardware stores are great.
Also thrift stores and resale shops have lots of aluminum bowls and kitchen implements that can work well, or can be drilled etc. to work

• ▶ Reply

Permalink Reply by kendallcustoms on January 3, 2009 at 2:57am

Thought the brass drain covers would be to much, amd take away from this simple yet elegant looking box. so I did end up turning a set of four, then dyed them a deep red to match box and the red tones of the neck. I'm going to throw a coat of clear over them but here's how they came out.

• ▶ Reply

Permalink Reply by kendallcustoms on January 3, 2009 at 9:17am

kendallcustoms said:

Thought the brass drain covers would be to much, amd take away from this simple yet elegant looking box. so I did end up turning a set of four, then dyed them a deep red to match box and the red tones of the neck. I'm going to throw a coat of clear over them but here's how they came out.

Attachments:

• DSCI0003.JPG, 31 KB

• ▶ Reply