Comment

Comment by Phill Hill Charlie on March 3, 2013 at 10:59pm

Tank you very much for sharin...°<[:-) [---]==={...

Comment by Mountain Voodoo (G B Miller) on March 1, 2013 at 5:19am

Thanks for the feedback everyone!

Randy, a Dremel that close to my birdseye maple or old growth walnut scares the shit out of me. I have screwed up more than one fretboard with power tools :)

Comment by ROBERT GREGORY on March 1, 2013 at 5:18am

Thanks for posting this. Nicely produced.

Comment by Randy S. Bretz on February 28, 2013 at 4:14pm

That same idea with the nippers was done by jim frets years ago...he might still have some vid`s on youtube. You should check him out....he was building bad ass homemade guits when we were all youngins.

Comment by Randy S. Bretz on February 28, 2013 at 4:11pm

well since i do 95% of my custom work with a dremel it`s a no brainer to use it for dressing frets.

Comment by Randy S. Bretz on February 28, 2013 at 3:41pm

I use a diamond disc on my dremel , cuts the fretwire at an angle plus i can use the surface of the disc to fine sand the end of the fret.

Comment by Bad Wolf on February 28, 2013 at 9:22am

harbor freight has knippers for $7. 20% coupon gets them for under $6

Comment by Craig Mayhem on February 28, 2013 at 9:17am

cool. Now how do I make a grinder? just kidding. Great tip!