Looking to do my first amp project and have a noob question. 

I've been looking at a lot of designs for ideas on the interwebs and have noticed that nobody ever uses a 2 or 3-way car speaker in their amp builds.  Does it always HAVE to be a full range speaker?  Does it have something to do with crossovers that complicate matters?  Just wondering because I have functioning car speaker, just not full range ones.

Thanks in advance!

Chuck

Views: 651

Reply to This

Replies to This Discussion

Most important is to match the speaker ohm rating to the amp circuit. Most cbg amp circuits require either/or a 4 or 8 ohm speaker. But I have seen a few cbg amps on Youtube that were made with car speakers. Another consideration is the watt rating. A car speaker that is rated for 50-300 watts really needs the extra power to operate at optimum performance and sound quality. Most cbg amp circuits are rated for 1/2 to 5 watts, with some alternate all-purpose amp circuits available online that are rated at 25 watts or so.

Thanks for the quick reply!

So even if I can match the ohm rating to the amp circuit, chances are I'm not going to find a car speaker that will work well with the 5 watts or less amps from Guitar Fuel, etc. 

Correct?

 

Chuck

You'll likely get some sound. But the higher the car speaker's wattage rating, the further it will get from sounding good.

You can always connect the amp circuit to the speaker BEFORE installing it into a box to see what it does do. If you like it outside of the box, chances are it will sound even better inside the box, since the enclosure helps with the overall tone f the whole package.

A good and reliable option is to try a thrift shop. Always find used stereo speakers in the 3-6" range, 2-20 watts and 4 or 8 ohms that will only set you back about $3 to $5, maybe even for a pair.

To add to this, I have used full range speakers from a 6" stereo speaker rated as high as 20 watts with good results. So you're not limited to speakers in the 5 watt or under class.

Thanks everyone for the ideas and guidance.  It's not that I'm opposed to using something other than car speakers, it's just what I already have lying around.  I like the TV speaker idea. 

I'm also thinking of building a small cab and running a 5 watt Hotone Nano head through it.  It runs 4-16 ohm speakers, but then again, it's just 5 watts.

I have successfully used cheap car 3-way speakers, but I have found that, so far, my old paper cone JBL 6.5" full range speakers sound the best on my cheap DIY amps...

They work, but a lightweight paper cone is hard to beat.   Go down to you local car stereo shop, they will have pulls from car installations... Most will let you have old speakers for very little, if not free...

John

Your car speaker is probably 4 or 8 ohms. With that out of the way, I say "Give it a try" Since you already have the speaker, hook it up to your amp circuit, plug in your CBG and try it out. I did that before building a cabinet and found that the two 3-way car speakers I had sounded pretty good with the cheap low watt amp circuit board I found on ebay. After that I built the cabinet and moved on to other projects.

Now, this isn't a stage-level amp, but is great for practice in the garage.

Or as an old bartender friend used to say as he drained a glass before putting it in to the wash "Waste no want not..........."

This is the angle I should have come at this with, but learned something from everyone, which is the whole idea of these forums!!!

Chuck, the above advice is all great, but I would just like to clarify one point: using car speakers in homemade amps is much less likely to give you a herpes infection than the actions of Tom's bartender friend.
All the best from Bill. :D

I would pass the warning along if it didn't go back forty years to college days. His theory was that the alcohol did double duty as an antiseptic (easy to justify any behavior when you're twenty something).

Still good advice.

I have gone around this a lot, low watt amps need efficient speakers, which are more expensive.

 I also have a roland microcube which also exelent if you put a better speaker in it.

Lots of things around like this:

http://www.ebay.ca/itm/201128958032?ssPageName=STRK:MEWNX:IT&_t...

 And you can buy a laptop charger for a few bucks to power it, but it is not portable.

Something like this will make it portable:

http://www.ebay.ca/itm/181112543103?ssPageName=STRK:MEWNX:IT&_t...

 it can then be run by a bunch of triple A batteries.

 good luck  Ron

RSS

The Essential Pages

New to Cigar Box Nation? How to Play Cigar Box GuitarsFree Plans & How to Build Cigar Box GuitarsCigar Box Guitar Building Basics

Site Sponsor

Recommended Links & Resources


Forum

Nut

Started by Bill Andy in Performances, How to Play, Lessons, Concerts. Last reply by Taffy Evans yesterday. 6 Replies

crossover guitar.

Started by Timothy Hunter in Other stuff - off topic, fun stuff, whatever. Last reply by Timothy Hunter Apr 10. 14 Replies

Tune up songs

Started by Ghostbuttons in Building Secrets, Tips, Advice, Discussion. Last reply by Timothy Hunter Mar 9. 5 Replies

Duel output jacks

Started by Justin Stanchfield in Building Secrets, Tips, Advice, Discussion. Last reply by Taffy Evans Mar 8. 6 Replies

Latest Activity

BrianQ. left a comment for Sam Tringali
44 minutes ago
BrianQ. liked Doug Thorsvik's video
45 minutes ago
Southern Ray replied to Bill Andy's discussion Copper Hardware
"Taffy makes good points. I have no experience either with the paint, but I have a bunch of 50+ year…"
1 hour ago
Doug Thorsvik posted a video

California Dreaming: 3D Printed Cigar Box Guitar

Cigar Box Guitar Slingers - Spokane, 201st Zoom Mtg 05/06/24. Only 1-finger chords, free songbooks here: https://www.cbgslinger.com/download CBG Songbook.pdf...
4 hours ago
Uncle John commented on Ghostbuttons's photo
Thumbnail

2 night project

"Very nice.  A clean and handsome fretless."
4 hours ago
Uncle John commented on Wanhavihtahousu's photo
Thumbnail

IMG_5132

"Those look great!"
4 hours ago
Uncle John commented on Wanhavihtahousu's photo
Thumbnail

IMG_5132

"Cool!"
4 hours ago
Sam Tringali is now a member of Cigar Box Nation
4 hours ago
A.D.EKER commented on AGP #'s photo
Thumbnail

AGP #533 - ''Beware of Wife''

"Thats a Beauty Alan whit the found riverwood and the Sign! i can hear it allready tearing it up!"
5 hours ago
Korrigan replied to Bill Andy's discussion Copper Hardware
"Did you click my link?  I'm seeing  lot of options."
6 hours ago
Mick Tickner commented on Mick Tickner's photo
Thumbnail

cbg2.4

"Ah so it's called a wing, thanks for that Doug.  And a bit ratty is exactly the look I…"
6 hours ago
Taffy Evans replied to Bill Andy's discussion Copper Hardware
"Hi, there is copper based paint available, and it actually creates a patina over time. I have not…"
10 hours ago

Music

© 2024   Created by Ben "C. B. Gitty" Baker.   Powered by

Badges  |  Report an Issue  |  Terms of Service

\uastyle>\ud/** Scrollup **/\ud.scrollup {\ud background: url("https://storage.ning.com/topology/rest/1.0/file/get/963882636?profile=original") no-repeat scroll 0 0 transparent;\ud bottom: 25px;\ud display: inline !important;\ud height: 40px;\ud opacity: 0.3 !important;\ud position: fixed;\ud right: 30px;\ud text-indent: -9999px;\ud width: 40px;\ud z-index: 999;\ud}\ud.scrollup:hover {\ud opacity:0.99!important;\ud}\ud \uascript type="text/javascript">\ud x$(document).ready(function(){\ud x$(window).scroll(function(){\ud if (x$(this).scrollTop() > 100) {\ud x$('.scrollup').fadeIn();\ud } else {\ud x$('.scrollup').fadeOut();\ud }\ud });\ud x$('.scrollup').click(function(){\ud x$("html, body").animate({ scrollTop: 0 }, 600);\ud return false;\ud });\ud });\ud \ua!-- End Scroll Up -->