Replies to This Discussion

Permalink Reply by Paul Craig on May 19, 2016 at 5:05am

If you want a open back or a closed back, you can have either one you want.

Permalink Reply by Paul Craig on May 19, 2016 at 5:06am

Thanks, I'm glad to get it done.

Permalink Reply by Paul Craig on May 24, 2016 at 8:10pm

Almost every guitar and CBG played with this amp comes out sounding very bright. Guessing it's the speaker that is doing that because the original/first amp that I made was used with a different speaker and was less bright sounding.

Thinking of adding a tone pot to take away some of the brightness if that is wanted. I'll give it a try out this week.

Permalink Reply by Paul Craig on May 24, 2016 at 8:11pm

The speaker has a break in time period and might get a little darker later, but a tone pot would still be a good idea if it works okay.

Permalink Reply by Paul Craig on May 26, 2016 at 6:54pm

The tone circuit helped tame the brightness a tad. I had 2 choices, put a tone pot in before the signal got to the chips or put 2 tone pots on the output lines that would probably mess with the volume too much. So I chose to put it in before the signal gets to the chips.

Drew out the new schematic.

• ‹ Previous
• 1
• …
• 5
• 6
• 7
• Next ›
• Page