Replies to This Discussion

Permalink Reply by Paul Craig on September 13, 2015 at 11:23am

I used them on my CBG(pic in my avatar and on my photos). I cut the wire that linked the pups and wired them as separate singles to a 4-way switch to get position 1-B, position 2-B&N parallel, position 3-N, position 4-B&N series. Wired to a 250k volume and straight to jack. The string spacing was great(4 string). The pickups sound okay. Neck pup is dark, but not muddy. Bridge is good, but the best position is #4. The pups together read at 8 ohm resistance but are 4 ohms separate and on the weak side. I think it would have worked out better to leave them together(no switch, just volume pot) and mount them right in the middle of the sound board.

• ▶ Reply

Permalink Reply by Matt Quinney on September 14, 2015 at 12:24am

Thank you!  I think I'll give it a try....

• ▶ Reply