Replies to This Discussion

Permalink Reply by Ron "Oily" Sprague on August 24, 2015 at 6:25am

Ummm...Mark? The package on the smaller ones says "1 Inch Screened Brass Grommet." That 1" is the outer diameter.

To be fair, a 1" diam soundhole is perfect for a standard cigar box. The bigger the hole, the higher the frequencies the box top will transmit, all else being equal. Smaller hole focuses the lower brassier freqs.

And if this is the same git as the mag pup, does it really matter?

• ▶ Reply

Permalink Reply by Mark Jeghers on August 24, 2015 at 7:36am

Understood, but the inner diameter is smaller.  I'd like something just a little bigger.  Maybe 1.5" outer diameter.

• ▶ Reply

Permalink Reply by Ron "Oily" Sprague on August 24, 2015 at 3:59pm

Gotcha. Only things I could find were 1.5" unscreened curtain grommets on Amazon.

• ▶ Reply

Permalink Reply by Terry Brennan on August 25, 2015 at 1:57pm

Mark, I just ordered some 1 7/8" outside diameter (about 1" inside) grommets from Gitty. There is no screen on them, but I like that look. they are listed under grommets and bushings page two. #32-104-01 for nickel and #32-101-01 for brass. I'm putting one in a Punch box build, and it seems about medium to me. I hope this helps. 

• ▶ Reply

Permalink Reply by A.D.EKER on September 3, 2015 at 11:27am

Copy in any size ,draw on box, and cut whit hand saw or nife.

• ▶ Reply

Permalink Reply by Don Cook on September 3, 2015 at 2:08pm

I haven't bought or used them yet...but I look up on eBay some small tweeter speaker grills. They would probably still be too big. I've seen people use computer fan guards as well. They make them pretty small. Its a different look though.

• ▶ Reply

Permalink Reply by Surly on September 3, 2015 at 4:42pm

Washtub strainer, tea infuser, poke some holes in the bottom of a pop can or food can, McMaster Carr sells stainless mesh in sheets...pricey though. Maybe an old slotted spoon from the flea market...

• ▶ Reply