Replies to This Discussion

Permalink Reply by MichaelS Country Boy Guitars on April 24, 2012 at 10:05am

If you put it on top, then put a fret board over the top it covers the line. Look at store bought guitars, this is how they do it on scarfed headstocks. But either way will work

• ▶ Reply

Permalink Reply by Bad Finger (Eric) on April 24, 2012 at 10:09am

Seems to me the strongest configuration is the little part on top with a separate fret board.  It's the way I've done all one of my scarf joints so far.

• ▶ Reply

Permalink Reply by Andy Eight Spades CBG on April 24, 2012 at 11:06am

Either will work.  Some people laminate a thin piece over the top of the headstock when they do it like you did the first time so you can't see the line running through it.  Just depends on what you like.  I always do mine with the headstock piece on top and then a seperate fretboard.

• ▶ Reply

Permalink Reply by Jon Pruett on April 24, 2012 at 3:07pm

I've found both to be very strong - as folks have said, one way the fret board covers the joint, the other way just needs a veneer over the face of the headstock to clean things up.

So remember - no rules!! (Except for that one about sand it one more time...)

• ▶ Reply

Permalink Reply by William McCauley on April 25, 2012 at 6:43am

I do it both ways, sometimes I have a line, sometimes not. Also, I usually cut the scarf length wise and then laminate the cutoff, or a contrasting piece of wood,  on the bottom to get tuners lower.

Attachments:

• 100_2145.JPG, 302 KB

• ▶ Reply

Permalink Reply by William McCauley on April 25, 2012 at 6:43am

I do it both ways, sometimes I have a line, sometimes not. Also, I usually cut the scarf length wise and then laminate the cutoff on the bottom to get tuners lower.

• ▶ Reply