I've long admired the Gibson hollow-body and semi-hollow-body line of guitars like the ES 330. They just look like a proper blues rig.

Since I was between builds and had tuners, pickups, frets, etc sitting around I figured "Why not build a 3-string Gibson tribute guitar". So I found a nice image of a Gibson and resized it to use as a pattern.

Since I don't want to be accused of being a "Chit head" by Uncle John, I've attached a few build photos for reference.

The sides were jig-sawed from 3/4" Poplar. Two courses glued up to create a body that was 1 1/2" deep.

The top and bottom were cut from 1/4" Poplar boards that were thinned to 3/16". The top is glued in place while the bottom attaches with screws. The F-holes were cut with a little hand held hobby saw. Not my favorite part of the job.

The neck is tapered from 1 1/2" where it enters the body to 1 1/8" at the nut. The fret board is screwed in place so it can be removed if necessary. A length of piano wire is used as a zero fret.

The sunburst finish was done with an airbrush. First, a bright yellow stain was applied to the entire body. This is what causes the finish to have warm depth. Minwax Sedona Red stain was airbrushed to create the orange/red fade. Common black latex from Home Depot was thinned and airbrushed to create the black fade. Finally, Orange shellac was airbrushed over the finish to stabilize the finish before several coats of shellac were hand rubbed to create some depth and protection for the finish.

The guitar has a 24" scale and uses a single wound, four-pole bass pickup that I picked up as a two pickup set wired to act as humbucker. Used as a single wound, I was worried about possible hum, but here is absolutely no hum from the pickup. I have a one-meg tone control with a 0.047mf cap.

Still sorting out preferred string diameters, but so far, it is a good player and my tribute to a Gibson blues classic.