Comment

Comment by ChickenboneJohn on September 9, 2010 at 9:50pm

Very fine piece of craftsmanship..just right.

Comment by JUJU on September 9, 2010 at 8:04pm

Thanks NAZ
i used SS because the original was Zink Plated and i'm not able to do that so i chose SS but dulled it off to age it some

Comment by Naz Nomad on September 9, 2010 at 8:41am

Nice looking tailpiece ... Tiny holes, and you only snapped four bits, you done good. SS is a biatch, that's probably why we don't see much of it on here. :-))

Comment by JUJU on February 13, 2010 at 11:04pm

yep it's not the best material to work with - oh yes i've seen those water jet cutters in action there Awesome
juju.

Comment by JUJU on January 29, 2010 at 12:59pm

Thanks very much Bob - it was a little bugger to make the only thing i had to go on was a few photos and a Rubbing that was taken from the butt of the guitar where the original tail lived which had left marks also marks were left where the Ball end of the strings had marked the top of the guitar body - i actually snapped four 2mm drill bits drilling the holes for the rivets , cant even remember the last time i snapped a drill bit :-(
Cheers mate
juju.