Comment

Comment by Monterey on March 2, 2015 at 2:40am

NP Gary, I was looking for the Forsner's, but couldn't find anything that small. But these Brad ones work great, they don't wander with that point on them, and they're real sharp, they have a nice clean cut. I made some practice holes first on a piece of scrap hardwood to get the depth and size right

Comment by gary sheldon on March 1, 2015 at 6:51pm

OK, Monteray, I found the pic of the bits and they look better than the crap bits I have been using.  Thanks for that.  I'll give the hardware store a visit tomorrow and see if they have them,  I did buy some Forsner bits a few days ago, but the smallest is 1/4".

Thanks for following up on that.

Comment by Monterey on March 1, 2015 at 6:12pm

I'll post a picture- got these at Canadian Tire

Comment by gary sheldon on March 1, 2015 at 5:27pm

I am not sure I know what a brad point bit is.  Can you educate me on that?