Comment

Comment by Scott W on January 5, 2015 at 12:28pm

A foot made of cheap pine worked well for a single instrument, but I am planning on putting a layer of scrap plastic cutting board material on the pressing surface. The pine is easily dented by the fret wire, which works well for not denting the fretboard, but the indentations in the foot requires carefully pressing a few times on each fret.

Comment by gary herget on January 5, 2015 at 12:20pm

Such concentration, whew!!

Comment by smilingdog1 on January 5, 2015 at 10:29am

Here you are converting your drill press into an arbor press! Impressive considering I still hammer my frets in.

Comment by Joe Caruso on January 5, 2015 at 6:12am

I like this - thanks for sharing.