Just got one for use with a fret burner. Since it is a power supply usable several ways, is it a viable idea to put a dimmer switch between the Variac and whatever is being powered? That way you could set the voltage on the Variac, but do the controlling with the dimmer,  the dimmer maxing out at the set voltage. With proper operation, you'd never blow anything up, the power can never go overlooad.

Views: 231

Reply to This

Replies to This Discussion

im with Cause here. not a safe way at all. if you want to use nichrome wire to burn fret markers there are safe ways. https://www.youtube.com/watch?v=qzaHd-BmROA

this video shows using a 9V battery. notice how hot, glowing red the wire gets! that will seriously burn you if not careful. the video also shows how you dont need a lot of voltage to make the wire hot enough to burn wood.

what you need is a cover that closes a switch when closed. as well as 2 other buttons in series,one either side of the cover. make it so the wire can not get hot unless all 3 switches are closed. ie place the wire where it is to burn. close the lid press the left switch with the left hand and the right switch with the right. 

this way you can not ever burn anything accidentally.

Kinda complex, but I understand the interlocks. Maybe a micro switch with a couple intermittent push buttons...

The 'build stuff to be able to build other stuff is piling up...

I've used a hot wire for years to cut foam for model airplanes. The first thing you notice is his use of a 12V battery charger.   This doesn't eliminate the burn risk, but brings the voltage to a safe level.

Modern battery chargers are electronic, and won't work... you need an older one that doesn't auto-cutoff or look for a battery. (Basically, see if it produces 14ish volts with nothing connected on the battery end.)

THEN you can use your variac to reduce the voltage to what you need...

And no, a household dimmer is not necessary...

OK, what about 6 volt lantern batteries, with an on/off switch?

The whole idea of the dimmer was to act as a safety. If the Variac was set to 9-12 volts, doesn't matter what you do with the dimmer (or light switch for that matter) voltage will never go over 9-12 volts.

So is it the AC that everyone is worrying about? I can sell the variac on ebay...

RSS

The Essential Pages

New to Cigar Box Nation? How to Play Cigar Box GuitarsFree Plans & How to Build Cigar Box GuitarsCigar Box Guitar Building Basics

Site Sponsor

Recommended Links & Resources


Forum

Nut

Started by Bill Andy in Performances, How to Play, Lessons, Concerts. Last reply by Bill Andy yesterday. 5 Replies

crossover guitar.

Started by Timothy Hunter in Other stuff - off topic, fun stuff, whatever. Last reply by Timothy Hunter Apr 10. 14 Replies

Tune up songs

Started by Ghostbuttons in Building Secrets, Tips, Advice, Discussion. Last reply by Timothy Hunter Mar 9. 5 Replies

Duel output jacks

Started by Justin Stanchfield in Building Secrets, Tips, Advice, Discussion. Last reply by Taffy Evans Mar 8. 6 Replies

Latest Activity

Carl Floyd replied to Bill Andy's discussion Copper Hardware
1 hour ago
Glenn Kaiser commented on Glenn Kaiser's photo
Thumbnail

MAY 2024 Take Down Diddley

"Thanks Doug, will do :) -Glenn"
2 hours ago
Doug Thorsvik commented on Poorness Studios's video
Thumbnail

Rainbow Stew (low budget cover on cigar box guitar) | Merle Haggard

"A new one for me Kale, and I like it! I always enjoy your CBG covers. Happy Sunday!"
2 hours ago
Doug Thorsvik commented on Glenn Kaiser's photo
Thumbnail

MAY 2024 Take Down Diddley

"Clean and simple! Ready for a little Jailhouse Rock. Go for it Glenn!"
2 hours ago
Doug Thorsvik commented on AGP #'s photo
Thumbnail

AGP #533 - ''Beware of Wife''

"This one is definitely an attention getter Alan! I’m not brave enough to build one like this.…"
2 hours ago
Doug Thorsvik commented on A.D.EKER's photo
Thumbnail

Decoration on the Spider & Frog

"I like it Andries! "
2 hours ago
Doug Thorsvik commented on Mick Tickner's photo
Thumbnail

cbg2.4

"Me too! It’s a challenge to nail everything right out of the gate, so tweak them when you…"
2 hours ago
Poorness Studios posted a video

Rainbow Stew (low budget cover on cigar box guitar) | Merle Haggard

Happy Sunday folks. I've wanted to cover this 1981 Merle Haggard tune for a while and I decided today is the day. Here's a stripped down cover with nothing b...
3 hours ago
Doug Thorsvik commented on Doug Thorsvik's video
Thumbnail

On Top of Spaghetti: 3D Printed Cigar Box Guitar

"Thanks and glad you enjoyed this one Alan! Another Slinger requested song and fun to do. I really…"
3 hours ago
Uncle John commented on Mick Tickner's photo
Thumbnail

cbg1

"Very nice!"
3 hours ago
Uncle John commented on Mick Tickner's photo
Thumbnail

cbg2.4

"Yup.  I get it.  A bit ratty, funky much played and much enjoyed."
3 hours ago
Uncle John commented on Mick Tickner's photo
Thumbnail

cbg3.2

"Very handsome."
3 hours ago

Music

© 2024   Created by Ben "C. B. Gitty" Baker.   Powered by

Badges  |  Report an Issue  |  Terms of Service

\uastyle>\ud/** Scrollup **/\ud.scrollup {\ud background: url("https://storage.ning.com/topology/rest/1.0/file/get/963882636?profile=original") no-repeat scroll 0 0 transparent;\ud bottom: 25px;\ud display: inline !important;\ud height: 40px;\ud opacity: 0.3 !important;\ud position: fixed;\ud right: 30px;\ud text-indent: -9999px;\ud width: 40px;\ud z-index: 999;\ud}\ud.scrollup:hover {\ud opacity:0.99!important;\ud}\ud \uascript type="text/javascript">\ud x$(document).ready(function(){\ud x$(window).scroll(function(){\ud if (x$(this).scrollTop() > 100) {\ud x$('.scrollup').fadeIn();\ud } else {\ud x$('.scrollup').fadeOut();\ud }\ud });\ud x$('.scrollup').click(function(){\ud x$("html, body").animate({ scrollTop: 0 }, 600);\ud return false;\ud });\ud });\ud \ua!-- End Scroll Up -->