Replies to This Discussion

Permalink Reply by Suspect Device on August 11, 2012 at 8:07am

Elmers white glue or Titebond will work just fine.

• ▶ Reply

Permalink Reply by Mike Breen on August 11, 2012 at 8:16am

I have also used silicone caulking and Gel type crazy glue

• ▶ Reply

Permalink Reply by Dan Sleep on August 11, 2012 at 9:12am

I buy the 1 inch brass grommets from Gitty. Drill a 7/8 inch hole with a Forstner bit, and they press fit nice and tight.

• ▶ Reply

Permalink Reply by Huntz Meyer on August 12, 2012 at 4:05am

And chamfer the top edge of the hole to clear the radius so they sit flush with the top of the box.

• ▶ Reply

Permalink Reply by Maddog on August 12, 2012 at 4:59am

I drill my hole 1/8" to 3/16" bigger than the grommet hole then hot glue the space between the edge of the grommet and the hole on the backside of the box. I wear a glove on the hand that holds the grommet on the front side of the box so I don't burn the digits. Hold it in place for a minute os so and done. They do not move and will not fall out.

• ▶ Reply

Permalink Reply by Bill on August 12, 2012 at 2:30pm

Thanks everyone for ideas. These are much better than what I was thinking. I'm glad I asked. I think I'm going with the silicone, I kind of like that idea the best. I hope to build more than one so eventually I'll try these other ideas and see which one I like the best. 

Huntz, I'd like to do that in the future,  but at this point I don't have the tools or the knowledge to do that. That'll be another question when I'm ready. 

• ▶ Reply