Comment

Comment by Kim Mosier on September 24, 2022 at 8:56am

I’m liking finish! This is a nice guitar!! Miss

Comment by David Bowes on August 24, 2022 at 7:24am

From Amazon..... The bridge piece is too wide, I can not easily adjust it, I will need to find an alternative, or file some half moon slots.

Thanks for the idea

Comment by Michael Fred Johnson on August 23, 2022 at 11:51pm

David

Those screws look better, no shoulder under the knurled head.

Comment by David Bowes on August 23, 2022 at 9:24am

Comment by David Bowes on August 22, 2022 at 7:35am

Michael

Found the blog thanks.

Comment by Michael Fred Johnson on August 21, 2022 at 12:51am

David

I showed these in a short blog  "Simple adjustable bridge" .The threads are M4 x 25 long, unfortunately the ones I bought didn't have a full length thread so I ran a die nut down the unthreaded bit to give more adjustment.

The saddle is just a piece of stainless strip drilled 5mm at each end then folded down the centre line. Even though the holes are drilled oversize they close up when folded, so you will have to run a 4mm drill through after folding. Make sure the saddle is held tight when doing this it will try and screw itself up the flutes of the drill bit ! 

Comment by David Bowes on August 20, 2022 at 11:37pm

Found them on the Web. I was thinking of something similar, I will steal the idea thanks.

Comment by David Bowes on August 20, 2022 at 11:11pm

Very nice, I like the bridge. What are the