Comment

Comment by Doug Thorsvik on July 28, 2022 at 4:13am

Thanks Rich! Yes Uncle John! Printed on a 3D printer in 2 pieces, ends down. 4.5 hours to print each (actually a short print compared to what others do, but long for me) Since you can’t print onto mid air and I did not want to use supports the angled areas allow printing the posts to attach the plate too. I printed 4 washers to top them and make sure the plate doesn’t touch the ends and buzz.

Comment by Uncle John on July 28, 2022 at 1:00am

Yup, I like the design too.  Colors pretty good - depends on the plate.   Is that 'printed out' on a 3 D printer?   Those could be very handy.  And salable.  

Comment by Rich on July 27, 2022 at 11:59pm

very clean design