Comment

Comment by Uncle John on December 7, 2013 at 1:12pm

great idea on the hoop.

Comment by Mark Mowatt-Wilson on December 7, 2013 at 12:54pm

I managed to get a tight fit for the sound board by using a cheap embroidery hoop. I cut the hoops to fit inside the pan , then laminated the two hoops together. This formed a tight fit and once dry I slid it up so it stood proud of the pan. Glue was lightly applied to the hoop and the sound board , then I clamped it using bulldog clips. This resulted in a soundboard that doesn't need to be screwed down. I'm also going to try using the hoops to reinforce round cookie tins. Embroidery hoops cost about $3 Aud

Comment by Reeds Taylor on December 7, 2013 at 12:34pm

Pretty nice build!

Comment by Mark Mowatt-Wilson on December 7, 2013 at 11:52am

.......it comes with a free recipe inside !

Thanks for all the positive and encouraging comments

Comment by Uncle John on December 7, 2013 at 5:32am

WOW!   Nice design, work, sound holes, angles, and a great saddle.  But where's my cake?

Comment by the anonymous pick on December 7, 2013 at 5:09am

clean  !!  

Comment by Low Budget Luthier on December 7, 2013 at 4:30am

very nice build.