Replies to This Discussion

Permalink Reply by ChickenboneJohn on July 23, 2012 at 7:45pm

Loads of Strat necks get put into cigar box guitars...BUT firstly you'd need to make sure that the body is long enough to get the bridge on with the typical Strat 25 1/2 scale length. If it isn't, forget it, but if it is, then you'll need a centre block running down the back of the box to fix the neck to. Personally, for a first time cigarbox guitar, I'd build a 3 string fretless, and by all means recycle a Strat pickup..

• ▶ Reply

Permalink Reply by The Phrygian Kid on July 23, 2012 at 9:47pm

I'm with him, it's actually easier to make your own neck than it is to reliably attach a bolt on fender type neck. It can be done for sure ad you'll see plenty around here, but your own neck and a floating type bridge is an easier build IMHO to make the bolt in neck work you really gotta extend it into a thru neck type by bolting it onto another plank tat crosses the box On the inside or the box will likely collapse under the tension

• ▶ Reply

Permalink Reply by J.D. on July 11, 2016 at 3:34pm

I'm about to do a six string build using a strat or tele style bolt on neck. I'm going w a undercrown cigar box for the length I will need. I've seen several nice builds using a Strat ,Tele ,Gibson style bolt on necks and really like the out come/look. "hope mine goes as well as some of the others I've come across. Good luck w yours!

• ▶ Reply

Permalink Reply by Cause the Blue rat on July 11, 2016 at 4:42pm

i made my own box. Used 3/4 inch ply for the back. Attached the neck to that and ended up with a great guitar! 

• ▶ Reply

Permalink Reply by JL on July 12, 2016 at 12:29am

Yes you can use the strat neck, pickups, and bridge.  Just extend the bracing in the box out the end of the box far enough. 

Measure the nut to 12th fret, likely between 12 and 12 3/4 in. that is 1/2 the distance of the nut-to-bridge that you need to account for, 24 to 25 1/2 scale.

Lay out the neck and your cigar box on your work table, and put the bridge on the box where you think it will work, roughly 1/3 from the far end, 2/3 from the end you will attach the neck.  measure from the bridge saddles to the 12th fret, and from the 12th fret to the nut.  move the neck farther/close until these 2 measurements are the same.

THAT will show you how much wood needs to stick out of the box to bolt the neck onto.

• ▶ Reply

Permalink Reply by Barrie Collins on July 12, 2016 at 10:45pm

Yep it works this one is a solid body basically the guitar body cut down and rearranged to fit in a cigar box

Attachments:

• image.jpeg, 1.6 MB

• ▶ Reply