Replies to This Discussion

Permalink Reply by Ron "Oily" Sprague on June 26, 2016 at 8:26am

I think there's another way. Put the pickup OVER the strings. Take a look at the Lace Alumitone discussion here on CBN. We've managed, with a simple bar magnet, a thickish loop of copper wire, and a specific, quite small transformer, to recreate a quite powerful pickup that can be configured for a variety of situations. This type of pup would prevent the need for cutting into the neck at all.

• ▶ Reply

Permalink Reply by Mark Betzhold on June 26, 2016 at 8:41am

Oh wow, that's wild!  My knowledge of electronics is pretty limited, but I might be able to figure it out.  At the very least, I could probably figure out a way to suspend a flatpup-type thing above the strings.  It'd be ugly and kludgy, but there's definitely a certain appeal in that.  Thanks!

• ▶ Reply

Permalink Reply by Ron "Oily" Sprague on June 26, 2016 at 9:05am

The designs we've collectively come up with are eminently doable with minimal electronics skill. The beauty of it is, if you use relatively thick copper wire, you can basically bend an L shape to the height you need to get above the strings.

• ▶ Reply

Permalink Reply by Mark Betzhold on June 26, 2016 at 12:36pm

That's quite a design!  Based on this photo, it looks like there's a small cutout that the pickup fits into, and another piece of wood attached to the back of the neck, I'm guessing for reinforcement.  Am I correct about that?

• ▶ Reply

Permalink Reply by Mark Betzhold on July 9, 2016 at 4:09pm

Hey, that sounds great!  I watched your other video as well.  I like how you have two different volume knobs for the two pickups.  

• ▶ Reply

Permalink Reply by Rick Alexander on June 26, 2016 at 2:53pm

Hey Mark, I read your post earlier today, and followed the link for the diy flat pickup. I was able to make one with stuff I had. The thing works good! I'm going to post a picture. Thanks for putting that link in your post. 

• ▶ Reply

Permalink Reply by Mark Betzhold on June 26, 2016 at 3:19pm

Glad to hear it works well.  It seems remarkably simple.  I tried making one, and it didn't work, but I think I may have used wire that was too thick.  I only got about 200 turns before it got too beefy, and I'm guessing that wasn't enough.  Also, how did you go about mounting it to the guitar?

• ▶ Reply

Permalink Reply by Rick Alexander on June 26, 2016 at 3:49pm

I forgot to mention that I had proper 42ga wire from StewMac left over from 10 years ago, when I made a few pickups. I just soldered it to a jack and held it next to a git to test it. I think when I mount it, I will cut a whole in the box but won't need to notch the neck. Although, I have the neck braced anyway. The times I thought I didn't need to double the neck inside the box, I regretted it later. They sound funny when the neck isn't strong enough. 

• ▶ Reply