Replacing the head-stock and only the head-stock from a finished neck. Need creative ideas.

Built a beautiful mini dog bowl resonator 3 string finished the nut and fretboard and decided I wanted to try a cutout headstock. Terrible idea. The piece was not long enough to get all three tuners set on one side and the angle on the other side makes it impossible to place a tuner. shaped like a figure 4 if you can imagine.

So I have this fully glued up and no way to string it. I would like to just chop the top off and put something else up there but I can't work out how I would attach it.

So I have come to the mountain to ask the masters.

0 members like this

▶ Reply to This

Replies to This Discussion

Permalink Reply by Wade on August 4, 2018 at 6:34am

I would cut a scarf joint. You can then add a new headstock.

▶ Reply

Permalink Reply by Wade on August 4, 2018 at 6:34am

I would cut a scarf joint. You can then add a new headstock.

▶ Reply

Permalink Reply by Cause the Blue rat on August 4, 2018 at 8:53am

Agreed. I think a scarf joint would give you the largest gluing area.

▶ Reply

Permalink Reply by Kigar on August 4, 2018 at 9:13am

I agree with Wade, Cause (and the other Wade :) ). Otherwise you could fill the holes and glue additional bits and pieces to build it up and attempt a do over but it would be a lot of work

▶ Reply

Permalink Reply by Cause the Blue rat on August 4, 2018 at 7:42pm

Hi, I"m cause, that's Wade and my other brother Wade.

: )

▶ Reply

Permalink Reply by Slim Pickens on August 4, 2018 at 9:26am

Thanks, guys. Wasnt really thinking in that direction but it does make sense.

▶ Reply

Permalink Reply by Kigar on August 4, 2018 at 11:24am

Maybe a picture would help spur some other ideas.

▶ Reply

Permalink Reply by Taffy Evans on August 4, 2018 at 3:25pm

Hi, I have not had to do this on a CBG but dozens of times on full guitars. I have attached a couple of photos that should help with a lightbulb moment for you. All the methods I have used are based around what you see here but tailored to suit the style and quality of the guitar in question.

I think the method for your job would be the first one. After doing the joint I would put "ears" on the sides of the head making it wider and stronger. As in the uke head also shown, a veneer on the front of the p/h would hide your work. I would prefer this to trying to cut a scarf joint in an already finished guitar.

Good luck Taff