So I was looking at a friends shop the other day and I find this 2" dowel. Just looking at it it seems like if you ripped it long ways it might make a nice strong CBG neck. I figure I must be missing…Continue
"Looks like my first CBG is going to be pretty similar to this lovely thang. As you can imagine my "first" neck is not real pretty. But I refuse to give her up so I had a couple of these valentimes boxes laying around and the little…"
"My 2 cents is be careful.,.,feeding a dowel to a table saw can be tricky.,,.I would mount it to a "carrier" board.,., and be careful.,.,.,I tried ripping a baseball bat without the "carrier" board and I'm lucky to still be…"
"Have I seen that done recently with two-sided adhesive paper? use it to virtually laminate two or three sheets together then tape off the top and bottom lines to prevent tear out then slow and steady. Use hat air if they are slow to…"
"When I first started thinking of building I thought about Large tool handles ripped in half and then further shaped, Mostly because if done correctly it would unique and allow my ever loving laziness to persist. "
"They were remodeling a recovery home and I drove by. The workers had pulled off all the hand rails (maple) and had threw them in the dumpster. I asked if I could have them. My garage has a pile of maple and cherry 1 1/2 hand rail. I just flattened…"