Replies to This Discussion

Permalink Reply by BrianQ. on May 8, 2022 at 2:47pm

Here’s a better pic with the whole headstock,I didn’t add the other piece cuz I was showing where the guide was supposed to be positioned? 

Permalink Reply by Taffy Evans on May 8, 2022 at 9:56pm

 That's what I'm talking about. Thanks, BQ.

Taff

Permalink Reply by Al Lobe on May 10, 2022 at 11:27am

Grateful to all of you and Customer Service. Their answer, which corresponds with yours:
"The slotted nut has been replaced by the retainer. Lay that flush against the edge of the fretboard...
You fit the strings through the slots before you wind around the [tuners]. This will provided tension for the strings to remain securely on the Zero Fret."

Permalink Reply by Taffy Evans on May 10, 2022 at 4:14pm

Hi, this system I imagine is due to the tuner post being higher or as high as the fingerboard. It will I think put upward pressure on the spacer from the strings so secure it well. A slotted spacer would have downward pressure holding it firm.
Taff

Permalink Reply by BrianQ. on May 10, 2022 at 5:48pm

Looking at it without the tuners, it would seem that way. But, with the tuners installed, the string holes are actually lower than the guide holes, so it does have downward pressure on the string guide? I think the angle of the pic is fooling your eyes, I’ll confess to taking a crappy picture & ask your forgiveness  :) 

• ‹ Previous
• 1
• 2
• Next ›
• Page