Replies to This Discussion

Permalink Reply by BrianQ. on August 28, 2020 at 6:51am

I guess you know what to ask for Xmas then?

• ▶ Reply

Permalink Reply by Greg Turner on August 28, 2020 at 7:51am

• ▶ Reply

Permalink Reply by Taffy Evans on August 28, 2020 at 4:30pm

Hi, my first thought is to put a drum sander in your electric drill, don't tell me you ain't got no drill. Do it free hand or clamp the drill into your vice. If you haven't got a vice see BrianQ's suggestion and make that Xmas list longer.
Taff

• ▶ Reply

Permalink Reply by Greg Turner on August 28, 2020 at 7:47pm

Got a drill. Drum sander you say. Hmmm...

• ▶ Reply

Permalink Reply by Taffy Evans on August 28, 2020 at 8:24pm

Hi Greg, I'm not sure what you are t tying to do. The top and back are normally cut oversize and overhang the sides when glued to them. I use a router to then trim top and back flush with the sides. In the absence of a router a drum sander would the job. Even better if it has a guide on the bottom like this one. Prevents sanding into the sides.

Taff

• ▶ Reply

Permalink Reply by Greg Turner on August 29, 2020 at 9:49am

Yes, they overlap the edges. Ok. Router and a guide. No router yet. Perhaps eventually.

• ▶ Reply

Permalink Reply by Greg Turner on August 29, 2020 at 9:49pm

Yes. It overhangs. Router or drum sander sound like the solutions.

• ▶ Reply

Permalink Reply by Titch the Clown on August 30, 2020 at 5:01pm

All you need is a  good sharp chisel. The technique is shown at about 2:14 into this video

https://youtu.be/MxapCiRm278

• ▶ Reply

Permalink Reply by Taffy Evans on August 30, 2020 at 7:49pm

Hi, if you are looking to save on elbow grease Greg a chisel may not be the best option, ya still gotta use sandpaper afterwards. B it if you go that chisel route, watch grain direction.

Taff

• ▶ Reply