Replies to This Discussion

Permalink Reply by Bluesheart on January 11, 2018 at 7:06am

Hand fret press adapted from window glazing point tool, works perfectly, no hammering in frets.

• ▶ Reply

Permalink Reply by Joe Caruso on January 11, 2018 at 7:33am

I have one somewhere - have to give this a whirl.

• ▶ Reply

Permalink Reply by Taffy Evans on January 11, 2018 at 9:28am

I like that, very creative 

Taff

• ▶ Reply

Permalink Reply by Paul Craig on January 12, 2018 at 11:44am

I'll have to try that one out soon.

• ▶ Reply

Permalink Reply by Taffy Evans on January 11, 2018 at 4:17pm

Saws………I posted this in the wrong place earlier...

These photos show two Japanese pull saw blades I bought, no handles, for about $12.00 each. I put a handle on one of them, but as the blade was pretty thin and flexible I had to modify it and others,

What I did was to take the blades out of non-serviceable backsaws, cut the pull saws to the size I needed, and fitted them in their place. I also made blades shorter so less flexible.

 Also shown are some other specialty saws one using hacksaw blades, all have their own special uses.

The hacksaw modified saw can have blades added to cut different size slots, in a bridge for a saddle, for instance. A slot is shown cut into a scrap of ebony three blades wide.

• ▶ Reply

Permalink Reply by Paul Craig on January 12, 2018 at 11:46am

Like those ideas.

• ▶ Reply

Permalink Reply by Taffy Evans on January 16, 2018 at 10:49am

Thanks Craig.

Taff

• ▶ Reply

Permalink Reply by Taffy Evans on January 16, 2018 at 10:59am

Hi, Here is my next offering. On the no hammering fretting method.

This press was made out of one of the hobby drill press that one puts their electric hand drill into. Or you could use your existing drill press if you have one.

I bolt it to the bench and set it up as shown. I use the brass fittings from Stumac. I can fret fingerboards only or the complete neck/fingerboard.

Cheers Taff.

• ▶ Reply

Permalink Reply by Timothy Hunter on January 16, 2018 at 11:43pm

should be able to modify my old bottle capper . gone to PET bottles for home brew now...

• ▶ Reply

Permalink Reply by Kirk on January 18, 2018 at 3:40am

Does Stew Mac offer a non radius brass fitting?

• ▶ Reply

Permalink Reply by Paul Craig on January 18, 2018 at 8:05am

Item #4375 for $4.86

• ▶ Reply

Permalink Reply by Taffy Evans on January 18, 2018 at 5:58pm

Yes they do that's what I use. or you could buy your favorite radius and put it in the holder upside down, you'll just have to file a suitable groove in the flat side to locate the fret.

Taff

• ▶ Reply

• ‹ Previous
• 1
• 2
• 3
• 4
• Next ›
• Page