Replies to This Discussion

Permalink Reply by Mister Scott on July 20, 2010 at 4:38pm

How did you curve the underside of the headstock (as seen in picture 2)? It looks more like a continuous piece of wood rather than a scarf joint.

Permalink Reply by Josh Gayou (SmokehouseGuitars) on July 21, 2010 at 5:23am

The long, painful way to do it is by blending the joint with a half-round file. I roll it out over a bench top belt sander.

Scotty C. said:

How did you curve the underside of the headstock (as seen in picture 2)? It looks more like a continuous piece of wood rather than a scarf joint.

Permalink Reply by Brett Morgan on July 31, 2010 at 5:42am

Josh is there any reason why you wouldn't shape the headstock before you make the scarf joint? It would seem that it would sit better being flat.

Brett

Permalink Reply by Bob Harrison on August 25, 2010 at 5:12pm

Josh, thanks for takeing the time out of your busy day to help everyone.

Cheers
Bob:)

Permalink Reply by Josh Gayou (SmokehouseGuitars) on August 25, 2010 at 6:27pm

Yes, if you leave it as square piece of wood, it's a lot easier to line up and get straight when you clamp the pieces together (when you make the scarf). If you have a cut headstock (especially if you do asymmetrical heads like I do) and you try to mate it up to the neck and clamp it, it might look just fine up close when you line it up but when you step away you'll realize that it bends off in one direction. If you clamp two square pieces together it's a lot easier to see that everything is straight because you can just lay a straight edge across it after you put the clamps on.

Brett Morgan said:

Josh is there any reason why you wouldn't shape the headstock before you make the scarf joint? It would seem that it would sit better being flat.

Brett

Permalink Reply by Josh Gayou (SmokehouseGuitars) on August 25, 2010 at 6:28pm

No worries :)

Bob Harrison said:

Josh, thanks for takeing the time out of your busy day to help everyone.

Cheers
Bob:)