Replies to This Discussion

Permalink Reply by Slowpaw Steve T on December 28, 2013 at 9:42pm

no need to glue it,  the string tension will keep the bridge in place, just make sure the base of the bridge is flat and level and not rocking in any way (-:

• ▶ Reply

Permalink Reply by Uncle John on December 29, 2013 at 3:45am

Steve is right.   But sometimes due to not great work or design, a bit of hot melt glue is in order.

• ▶ Reply

Permalink Reply by Barsymes Cratchnee on December 29, 2013 at 3:54pm

great.  will try it without then. base of bridge is pretty flat, no rocking at all.

• ▶ Reply

Permalink Reply by the anonymous pick on December 29, 2013 at 5:30pm

proper   ,   or   " enough" , downward    string angle behind the   bridge  will  hold it snug  . 

but  remember   too  much,  and too   close  ,   may   push it  forward  . 

• ▶ Reply

Permalink Reply by Ron "Oily" Sprague on December 29, 2013 at 10:25pm

Attach a flat steel plate to the bottom of the bridge. Place a bar magnet under the lid. Viola! No more bridge creep. Allows for setting compensation angle, too.

Next step, attach two wires, one at either end of the steel plate, and wire them to an output jack. Viola! Cheapy bridge pickup.

For my next trick, I'll disappear...

• ▶ Reply

Permalink Reply by Randy S. Bretz on December 29, 2013 at 11:38pm

Never had to glue one yet...proper design and install you shouldn`t need to glue it down.

• ▶ Reply

Permalink Reply by Yankee Dog on December 30, 2013 at 2:23am

be sure to put a couple of small witness marks on the box where the bridge goes. Sooner or later you will change strings or bump the bridge. The witness marks will show you where the bridge is suppose to go. Otherwise your intonatation will be off if you put the bridge back in the wrong spot.

 

 

• ▶ Reply

Permalink Reply by Thomas "Duck" Petry on December 30, 2013 at 12:20pm

Wipe a thin film of silicon adhesive on the surface that sits on the box and let it dry thoroughly and it will resist sliding but be movable if you desire. Make witness marks as Yankee Dog said to return it to the correct place should you unstring it.

• ▶ Reply