Replies to This Discussion

Permalink Reply by Wes "I'm Baaaaack" Yates on February 3, 2010 at 1:12am

Hmmmmm. Nothing comes to mind. I would be in the wrong if I suggested anything I thought was a substitute.

-WY

• ▶ Reply

Permalink Reply by Skeesix on February 3, 2010 at 2:03am

Back in the old days before recrowning files, they used a triangular file. You would move the file over each side of the fret to simulate a curve. You can get them at any hardware store for cheap. You should grind down the triangular edges a bit to keep from damaging the fret board.

Skeesix

• ▶ Reply

Permalink Reply by Wes "I'm Baaaaack" Yates on February 3, 2010 at 2:31am

On that note, I have seen (recently) a tip that uses cut pieces of soda can as fretboard shields.

-WY

Skeesix said:

Back in the old days before recrowning files, they used a triangular file. You would move the file over each side of the fret to simulate a curve. You can get them at any hardware store for cheap. You should grind down the triangular edges a bit to keep from damaging the fret board.

Skeesix

• ▶ Reply

Permalink Reply by Josh Gayou (SmokehouseGuitars) on February 3, 2010 at 9:48am

I bought an actual end dressing file off ebay for about what half stewmac charges.

• ▶ Reply