Photos

Fret dot holes...

Posted by Monterey on March 1, 2015 at 9:55pm
Freshly drilled with one of the new brad point wood drill bits I got for my Birthday- this went smoothly!
Read more…
Previous
Next
E-mail me when people leave their comments –
Follow

You need to be a member of Cigar Box Nation to add comments!

Join Cigar Box Nation

Comments

  • Monterey March 2, 2015 at 8:40am
    NP Gary, I was looking for the Forsner's, but couldn't find anything that small. But these Brad ones work great, they don't wander with that point on them, and they're real sharp, they have a nice clean cut. I made some practice holes first on a piece of scrap hardwood to get the depth and size right
  • gary sheldon March 2, 2015 at 12:51am

    OK, Monteray, I found the pic of the bits and they look better than the crap bits I have been using.  Thanks for that.  I'll give the hardware store a visit tomorrow and see if they have them,  I did buy some Forsner bits a few days ago, but the smallest is 1/4".

    Thanks for following up on that.

  • Monterey March 2, 2015 at 12:12am
    I'll post a picture- got these at Canadian Tire
  • gary sheldon March 1, 2015 at 11:27pm

    I am not sure I know what a brad point bit is.  Can you educate me on that?

This reply was deleted.