Comment

Comment by Doug Thorsvik on May 25, 2022 at 10:36pm

It does! Thanks AGP.

Comment by AGP # on May 25, 2022 at 9:06pm

"Thanks Doug", I probably should have taken a few more Pics of the building process but didn't, but basically I cut a hole 20mm smaller than this 190mm blade, and then run a 12mm wide x 3mm deep rebate with a router around the edge, under the screws, between the blade and the timber rebate, is a small 6mm grommet, small nuts or springs would have the same effect, which is to give the blade a bit more ring to it, rather than screwed directly onto the timber, which does tend to deaden the ring tone.

This is actually the fourth build I've done using circular saw blades, all attached in different ways, but unfortunately like this one, I neglected to take the build process Pics, I hope all this makes some sort of sense! ;-D  

Comment by Doug Thorsvik on May 24, 2022 at 11:45pm

I’m inspired AGP! I have a few saw blades hangin’ up in my workshop. How did you mount the blade? I can see the 4 screws, but not what is underneath.